Hot Melt Glue


There is high-temp hot melt, which works great but burns when touched and burns a lot when stuck to skin.

There is low-temp hot melt, which works ok, but doesn't seem to hold like high-temp glue. It is less likely to do serious damage to careless children.

Now there is glue that works as high-temp or low-temp. How does it do this? Chemistry? My current glue gun has a high-low switch that lets me have it both ways.

Tips for Working with Hot Melt Glue

I like hot melt glue more every time I use it. This must have something to do with getting good at it.

  • The glue gun takes many minutes to heat up to working temperature, maybe ten times slower than my pencil soldering iron. I let my glue gun idle on low-temp and then turn it up to high when I am ready to work.

  • Work on old newspaper. The gun oozes glue when hot. Let newspaper collect this for you. I reuse the same sports section over and over. Cold glue isn't messy so this works fine and saves filling my trash with newspaper.

  • Blobs of glue will stay hot and fluid so long as the heat has no where to go. A bead of glue run along the edge of FoamCoreBoard will cool the instant it squashed against another board. It is a surface area to volume issue. When the surface area is small, the heat is trapped. When the bead is squashed, the surface area grows and the heat escapes. How convenient.

  • When gluing unlike materials (say plastic and metal), apply the glue to the thermal insulator. When the parts are joined, the thermal conductor will cool the glue quickly.

  • Retracting the glue gun can leave a stringy fiber of glue between gun and work. Ignore this until the work is cool so that the fiber can be removed without extending it.

 

Last edited January 4, 2009
Return to WelcomeVisitors